EPM2000-41
2000W 48V TO 110/120Vac PURE SINE WAVE INVERTER
Single phase Pure sine wave inverter
Surge Power <4000W,Frequency50/60Hz
- Adoption of advanced SPWM technology, pure sine wave output
- Dynamic current loop control technology to ensure inverter reliable operation
- Wide DC input voltage range
- Low output harmonic distortion(THD≤2%)
- LED indicators for input voltage range, normal output & failure state
- Extensive protections: short-circuit, overload, under/over input voltage, over-temperature, and inverter's inner fault identification protections
- Temperature, and inverter's inner fault identification protections
- The output voltage and frequency can be switched
- Complete isolation-type inverter technology
- Optional energy SAV mode(saving mode)
- Wide working temperature range (industrial level)
- Continuous operation at full power
| Item | EPM2000-41 | EPM2000-42 |
| Electrical Parameters | ||
| Input rated voltage | 48V | |
| Input voltage range | 43.2~64Vdc | |
| No load current | ≤0.3A@48Vdc | ≤0.4A@48Vdc |
| Output voltage | 110/127Vac | 220/230Vac |
| Continuous power | 2000W | |
| Power 60sec | 2100~3000W | |
| Power 1.5sec | 3000~4000W | |
| Surge Power | <4000W | |
| Output Mode | Single-phase electricity | |
| Output wave | Pure sine wave | |
| Frequency | 50/60Hz | |
| Diatortion THD | THD≤2%(Resisitive load) | |
| Efficiency at full load *1 | 90.6% | 93% |
| Max. efficiency *2 | 93.1% | 94.2% |
| SAV mode |
0.23A; The load is detected every 10sec, if the output power is greaterthan 20W, it will output continuously |
0.2A; The load is detected every 10sec, if the output power is greaterthan 20W, it will output continuously |
| DC current | 45A | |
| Shutdown status | ＜1mA | |
| Fuse | 30A*4 | |
| Environment Parameters | ||
| Dimension | 421*228*124.5mm | |
| Hole Size | φ8mm | |
| Net weight | 5.4Kg | |
| Working temperature | -20℃~+50℃ | |
| Storage temperature | -35℃~+70℃ | |
| Humidity | ＜95%(N.C.) | |
| Altitude |
＜5000m（Derating to operate accoding to IEC62040 at a height exceeding 1000m） |
|
| Other Parameters | ||
| Insulation | Between AC output terminals and metal case: ≥550MΩ | |
| Dielectric strenth |
Between AC output terminals and metal case: Test voltage AC1500V, 1min |
|
| Application | Household appliances, cars, solar system and so on | |
|
* 1.The DC input is the rated voltage, and the pure resistive full load power is the continuous output power. * 2.The DC input is the rated voltage and the maximum efficiency under different load power conditions. * 3.Select the appropriate inverter according to the voltage standards of different countries. |
||
Application scenariosMORE >